Author Topic: Adjusting Path Width  (Read 1124 times)


  • Administrator
  • Hero Member
  • *****
  • Posts: 2799
Adjusting Path Width
« on: March 03, 2014, 10:30:23 AM »

Referring to the screenshot above:
1) Click on set path properties (red arrow)
2) Adjust the number where it says Road (green arrow) bigger number = wider path, smaller number = narrower path

NOTE: If the path has been already connected to another path only the free end will be adjusted, but if it is a separate path the entire path will be affected.
A Proud Backer Of TPS! If you are having trouble using TPS refer to
To report problems or make suggestions go to and register for an account.


SMF 2.0.8 | SMF © 2014, Simple Machines

Page created in 0.364 seconds with 21 queries.

Analysis © 2010 by, Crip